The Editor
Open it with Window > GlowingRifts > SoundGraph Editor, or double-click a .soundgraph asset.
⌨️ Working With Nodes
| Action | How |
|---|---|
| Add a node | Space or right-click |
| Wire | Drag from an output to an input |
| Duplicate | Ctrl+D |
| Copy and paste | Ctrl+C, Ctrl+V |
| Bypass | Ctrl+E, or right-click > Bypass. Effects pass their input through and sources go silent |
| Group | Ctrl+G boxes the selected nodes under a title. Ctrl+Shift+G removes the grouping |
| Stack | Drop a node’s top on another node’s bottom to dock it. A stack moves and collapses as one |
| Save | Ctrl+S or Save. A tab shows * while unsaved |
🧩 Blackboard
Open it from the toolbar. It holds the graph’s properties.
- Press + to add a Float, Vector 2, Bool, Trigger, Audio Clip, MIDI Clip or Scale.
- Drag a property onto the canvas, or right-click > Add Property, to get a node that outputs its value.
- Tick Exposed so scripts, UI and animations can set it through
SoundGraphSource. - Floats glide to new values over about 15 ms unless Smooth is off. Bools switch at once. A Trigger sends one short pulse.
👀 Previewing
▶ Preview plays the graph through the same engine a built game uses. Editing keeps the sound playing: wires, knobs, patterns and clips change it live.
- Live Wires: each wire glows with the signal going through it.
- Levels: a thin meter under every node. Green, yellow above -12 dBFS and red above -3 dBFS.
- Visualiser node: wire anything into it to see a scope, spectrum, meter, lissajous, value or notes view. Editor only.
- Play Mode: an open graph follows a SoundGraph Source that plays it (the selected one, or pick it from the ● Live menu). The Blackboard shows each property’s live value.
🎵 Tempo, Chords and Scales
- A global tempo lives on the graph. Tick sync on a node’s bpm input to follow it.
- Chords and scales travel on chord wires. Feed a chord, or a Blackboard Scale, into a Quantizer or Arpeggiator.
- Piano Roll, Step Sequencer and Chord Sequencer write notes and patterns on the node.
🥁 Clips and MIDI
Audio Sampler plays a clip. Pick one on the node, or wire an Audio Clip property into its clip input so a game can swap it. trig plays it, pitch shifts it in semitones, voct follows 1 V/oct, and start sets where it begins. Modes are one-shot, gate and loop.
Clip Sequencer has a row of beat slots per clip. Set beats, rate and bpm, add clips with + Clip or by dropping them on the node, and click (or drag across) slots to turn hits on and off.
Clips are read with AudioClip.GetData, so their Load Type must not be Streaming.
MIDI: drop a .mid file into the project and it imports as a MIDI Clip. MIDI Voices plays it as chords across a pool of voices.
🧱 Subgraphs
Build a reusable piece (a voice, an effect chain) as its own graph, with Subgraph Input and Subgraph Output nodes where wires go in and out. Each one’s name becomes a port. Add it to another graph from the Add menu’s Subgraphs group, and double-click it to open its graph.
Subgraphs are copied into the graph when it’s baked, so they cost nothing extra at runtime. Their nodes count towards the 128-node limit.